Installation; Switch Settings - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
6 - 38
128 (PZ-128IPLA) channels
Refer to the following table for maximum upgrade capacities of the
PZ-32IPLA,/PZ-64IPLA/PZ-128IPLA daughter boards:
Table 2-4 SV8100 Maximum System Capacities – Blades on
page 2-7
When installing an IPLA daughter board, thesystem allocates the
maximum number of trunk ports for the blade being installed.
This daughter board is installed on either the CD-CP00-AU or
CC-CP00.
3.5.2

Installation

To install a PZ-32IPLA/PZ-64IPLA/PZ-128IPLA on the CD-CP00-AU
or CC-CP00 :
1. With the system power off, remove the CD-CP00-AU or
CC-CP00.
2. Install the IPLA daughter board on the CD-CP00-AU or
CC-CP00 blade.
3. Insert the CD-CP00-AU into slot 1 in the Controlling Chassis or,
the CC-CP00 into the CHS1U-AU.
Refer to
page 4-25
4. Connect the IPLA daughter board to the CD-RTB or to an
external switching hub using an ethernet cable.
5. Refer to the UNIVERGE SV8100 Programming Manual for
detailed programming instructions
3.5.3

Switch Settings

This daughter board does not have any switch that needs to be set
and does not require any hardware setting.
Do not remove or install the CD-CP00-AU or
CC-CP00 with the power on.
Figure 4-25 19" Controlling Chassis – Guides Slot 1 on
for more details.
Installing the SV8100/SV8300 Blades
UNIVERGE SV8100/SV8300
.