Issue No. 1.5
12 - 12
Table 12-3 AP(A)-R( )/AP(R)-R( ) Unit Switch Settings
Switch
SW1
SW3
Dip
Switches
(DSW)
3.3.2
Installing AP(A)-R( ) or AP(R)-R( ) Unit on a Multiline Terminal
The AP(A)-R( ) or AP(R)-R( ) Unit should be installed after the
switches are set.
When wall mounting the Multiline Terminal, a WM-R( ) Unit must be used.
Refer to
1.
Prepare multiline terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation on
page
12-1.
2.
Plug the tabs marked A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked C.
Refer to
to the Multiline Terminal on page
SW1-1
Connects to multiline terminal (default).
SW1-2
Not Used
SW3-1
Sets impedance to 600
modems or facsimile machines.
SW3-2
Used for complex impedance devices such as
single line telephones.
DSW 1~8 Leave switches at default.
Section 11 Wall Mounting Multiline Terminals on page
Figure 12-17 Attaching the AP(A)-R( )/AP(R)-R( ) Unit
Installing D
UNIVERGE SV8100/SV8300
Description/Settings
Ω
for devices such as
12-13.
term
Series i Optional Equipment
11-16.