Table 10-3 Ada-L( ) Unit Switch Settings - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
To provide control to the recorder or to enable/disable the record start warning
tones, refer to Table 10-3 ADA-L( ) Unit Switch
Switch
Dip
Switches
(DSW)
12.3.2 Installing the ADA-L( ) Unit
Perform the following steps to connect the ADA-L( ) Unit to the Bottom
Option Interface located underneath the DTL/ITL multiline terminal.
Only one ADA-L( ) Unit can be installed at a time.
1. Unplug the line cord from the multiline terminal.
2. Turn the DTL/ITL multiline terminal upside down.

Table 10-3 ADA-L( ) Unit Switch Settings

Record Confirmation Tone
DSW 1 On = Tone On (Default)
Off = Tone Off
DSW 2 Used for Voice Inputting via a TRANS 2
and On = Disable
DSW 3 Off = Enable (Default)
Output Hook Signal to External Device
DSW 4 On = Output (Default)
Off = No Output
Current Level for OUT Jack
DSW 5 On = Low
Off = High (Default)
Not used
DSW 6
On = (Default)
DSW 7
Not used
and
Off = (Default)
DSW 8
To prevent possible damage to the ADA-L( )
Unit or the DTL/ITL multiline terminal
during installation or removal, disconnect
the line cord/LAN cable and the AC/DC
adapter from the DTL/ITL multiline terminal.
Issue No. 1.5
Settings.
Description/Settings
10 - 61