Led Indications; Figure 6-35 Install The Compact Flash Drive - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
5. Install the Compact Flash drive into slot CN7, make sure the
drive is fully seated in the slot (refer to
Compact Flash
6.1.3

LED Indications

6.1.3.1 Active LED – Green
The Active LED is controlled by the DSP and indicates the
board operational status.
6.1.3.2 Busy LED – Red
The Busy LED is controlled by the DSP and indicates the
port status.
6.1.3.3 Application LED – Red/Green (Dual Color)
The Application LED is controlled by the DSP indicates the
state of the software running on the APSU.
6.1.3.4 CompactFlash Card Activity LED – Red
Drive).

Figure 6-35 Install the Compact Flash Drive

Off: Power off.
On: Reset.
Slow Flash: Board is running but not in sync with the
chassis yet.
Fast Flash: Board is in sync with the chassis and
operating normally.
Off: Power off or idle.
On: Reset.
Off: Power off.
Solid Red/Green (Yellow): Reset.
Flashing Green: OS is running, application not started.
Solid Green: Application running.
Solid Red: Application problem.
Issue No. 1.5
Figure 6-35 Install the
6 - 91