Figure 10-14 Cd-Cp00-Au Page Connections - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
5. If a line cord was not previously connected to the PGD(2)-U( )
ADP, complete Steps 3-6. Otherwise, skip to Step 7.
6. Install a modular jack for each PGD(2)-U( ) ADP. For each
module, run one-pair 24 AWG station cable from the
cross-connect block to a modular jack. Ground the unused pair.
7. Terminate the extension leads to GRN/RED of the modular jack.
Terminate the unused leads to the jack.
8. Install bridging clips as required.
9. Plug a modular line cord from the mod jack to the CN1 connector
on the PGD(2)-U( ) ADP.
10. Connect the two-conductor station cable from the CN5
connectors in the PGD(2)-U( ) ADP to the external relay.
The relay closes when the Door Box/external
page zone is called. The maximum applied
voltage is 24vDC at .5A for each contact.

Figure 10-14 CD-CP00-AU Page Connections

Issue No. 1.5
10 - 17