Installation - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
2.1
9 - 2

Installation

The hardware installation consists of the following steps:
1. Determine the number of DAPs that needs to be installed and where they
should be located. Refer to NEC SIP DECT Solutions Technician's Guide,
DAP Planning as a guideline.
2. Read the sections
DECT Solutions Technician Guide carefully to determine how the DAPs
should be powered and how the cable must be run.
3. Make sure that you have an IP Switch available to connect the IP DECT
equipment. Power up the IP Switch.
4. Setup and connect the power provision for the DAPs. The LEDs on the
DAPs should show some activity.
5. Connect the DAP cables to the IP Switch.
Do not connect the Ethernet cables or the IP Switch to the local IP network. The
DECT configuration should be installed in a closed network.
6. Make sure that you have a computer available that can be used for
management. Connect this PC to the IP Switch using an ethernet cable.
Check that the lamp on the IP Switch indicates that the connection is
established.
7. (For UNIVERGE SV8100 only) Connect a network cable between the CD-
(X)ILPA and the IP Switch.
8. The next step is setting up your IP Addressing structure. Refer to the
NEC SIP DECT Solutions Technician's Guide, IP Addressing.
DAP Cabling and DAP Power Provision in the
Installing SV8100/SV8300 Wireless Telephones
UNIVERGE SV8100/SV8300
NEC SIP