Table 6-10 Cc-Cp00 Switch Settings - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
Reset
(Push Switch)
Sense
(Rotary Switch)
= For details, refer to Command Manual
6 - 26
4. If external Music on Hold (MOH) is being installed, plug the cable
into the CN8 or CN9 pin jack connector on the CPU. The other
end of the cable plugs into the music source.
3.2.3 Switch Settings
Refer to
system reset and with system power on.
on page 6-22
blade.
Setting
Switch
Position
–
0
1
2
3
4
8
A
E
F
5-7, B-D
Refer to the PGD(2)-U( ) ADP in
page 10-1 for details on connecting to a music source.
When the system software is upgraded, the flash memory is
updated with the new software version. Either Hot or Cold start-
up can be used or the system can be upgraded using system
software. Refer to 2.6.1 Performing a Cold Start on page
2.6.2 Performing a Hot Start on page
Software Upgrade on page
Customer information is stored in the RAM memory and is saved
when a power failure occurs. The lithium battery in the system
saves the RAM memoryt.

Table 6-10 CC-CP00 Switch Settings

shows the location of the switches on the CC-CP00
Table 6-10 CC-CP00 Switch Settings
For system reset
On-line (Call processing is in progress): for Remote Unit
On-line (Call processing is in progress): for Unit 1
On-line (Call processing is in progress): for Unit 2
On-line (Call processing is in progress): for Unit 3
On-line (Call processing is in progress): for Unit 4
Off-line (Call processing is stopped): Program upgrade (FTP)
Off-line (Call processing is stopped): Standard office data setting
Off-line (Call processing is stopped)
RS1/RS2 port: 9600bps fixed
ETHERNET/VOIP port: Default setting
Off-line (Call processing is stopped)
RS1/RS2 port: AS per CM40Y=08
ETHERNET/VOIP port: Default setting
Not Used
UNIVERGE SV8100/SV8300
Section 2 PGD(2)-U( ) ADP on
6-8, or 2.6.4 Performing a
6-11.
for system restart/
Figure 6-6 CC-CP00 Blade
Function
Installing the SV8100/SV8300 Blades
6-7,