Figure 10-49 Separate Tilt Leg From Leg Support; Figure 10-50 Bottom Option Interface Knockout; Figure 10-51 Install Ada-L( ) Unit - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
10 - 62
3. Lower the tilt leg to the first position (refer to
Separate Tilt Leg from Leg
Tilt Leg

Figure 10-49 Separate Tilt Leg from Leg Support

4. Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5. Lay the tilt leg and the leg support flat to expose ADA-L( ) Unit
compartment.
6. Carefully pry loose the knockout covering the bottom option
interface (refer to
Knockout).
Knockout

Figure 10-50 Bottom Option Interface Knockout

7. Using the exposed Bottom Option Interface as a guide, install
the ADA-L( ) Unit in the bottom of the DTL/ITL multiline terminal.
Push down until left and right tabs are seated (Refer to
10-51 Install ADA-L( )
Tab
Bottom Option
Interface
UNIVERGE SV8100/SV8300
Support).
Figure 10-50 Bottom Option Interface
Unit).

Figure 10-51 Install ADA-L( ) Unit

Installing SV8100/SV8300 Optional Equipment
Figure 10-49
Stoppers
Bottom Option
Interface
Figure
Tab