UNIVERGE SV8100/SV8300
System Hardware Manual
12.5.1
Installing the PSA-L( ) Adapter
1.
Turn the multiline terminal upside down.
2.
Unplug the line cord and handset cord from the multiline
terminal.
Only one PSA-L UNIT can be attached to the DTL/ITL multiline terminal.
3.
Lower the tilt leg to the first position (refer to
Separate Tilt Leg from Leg Support on page
4.
Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5.
Lay the tilt leg and the leg support flat.
Before installing or removing the PSA-L( )
adapter, remove the line cord, LAN cable, and
then AC adapter from the outlet.
Tilt Leg
Figure 10-61 Separate Tilt Leg from Leg Support
Issue No. 1.5
Figure 10-61
10-69).
Stoppers
10 - 69