Performing A Software Upgrade; Cd-Cp00-Au (Sv8100 Central Processing Unit) - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
2.6.4

Performing a Software Upgrade

This section describes the procedure to perform a software upgrade
on the CD-CP00-AU.
To save customer data prior to updating, a blank USB
Memory is required. Insert the USB Memory into the
USB Port on the CD-CP00-AU blade. Use Program
90-03 to save the software to the USB Memory. Note that
a USB Memory can hold only one customer database.
Each database to be saved requires its own separate USB
Drive. Use Program 90-04, with the database to be
restored installed in the CD-CP00-AU, to reload the
customer data if necessary.
After uploading programming data to the system using
Program 90-04, exit programming mode (this could take
a minute or more to save the database), then reset the
system by powering down and back up. Wait a few
minutes for the programming to take affect before
accessing any line or special system feature. Otherwise
some unusual LED indications may be experienced. To
prevent the USB Memory from possibly being
overwritten, remove the USB Memory after downloading
the database.
When restoring a database file, as the slot definitions may
be different, remove all blades from the system except the
CD-CP00-AU and CD-8DLCA/CD-16DLCA in slot 2.
After the system has been reset, the blades can be
reinstalled. Use Program 10-03 prior to updating to
record the current slot definitions.
To perform a system software and firmware upgrade:
1. Turn the system power off.
2. Once the system has powered down, insert the USB Memory
containing the software upgrade into the USB port on the
CD-CP00-AU.
3. Push in and hold the Load button.
4. Turn the system power on.
5. Continue holding the Load button for approximately 10 seconds
or until Status LED5 begins flashing red.
6. Release the Load button.
IMPORTANT CONSIDERATIONS
Issue No. 1.5
6 - 11