Order Of Installing Trunk Blades; Table 6-2 Adding Daughter Board To Chassis Example - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
Blade
Slot #
System Hardware Manual

Table 6-2 Adding Daughter Board to Chassis Example

Initial Blade
Blade
1 CD-16DLCA
2 CD-8DLCA
(no daughter
board)
3 CD-16DLCA
— —
The system automatically recognizes each blade installed in the
system.
If a blade has previously been installed
blade is to be installed in that same slot, the blade must first be
removed from the chassis and then the slot definition removed using
Program 90-05 prior to installing the new blade.
This same condition applies to extensions and other devices
connected to the system. For example, if a port was previously used
for a telephone and a DSS Console is to be installed in that same port,
the telephone must first be undefined in Program 10-03 before the
console is connected.
2.2.3

Order of Installing Trunk Blades

2.2.3.1 Installing
Extension Blade
Numbers Slot #
101~116
117~124
125~140
—
CD-4COTC,
CD-2BRIA Blades
The order in which trunk blades are physically inserted
determines the numbering plan.
To avoid unexpected extension/trunk
numbering if the VoIP or Voice Mail
blades register with the system first,
install these blades after the other types
of extension and trunk blades have been
installed.
Updated Blade
Blade
1 CD-16DLCA
2 —
3 CD-16DLCA
4 CD-8DLCA
(with daughter
board)
in a slot and another type of
CD-4DIOPA, CD-4ODTA
Issue No. 1.5
Extension
Numbers
101~116
—
125~140
141~156
or
6 - 5