Connectors; Table 6-12 Cc-Cp00 Connections - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
LED Color
ALM Red Status indications of MJ/MN alarm.
On
Blinking
Off
LINK Green Status indications of link on ETHERNET port.
On
Blinking
Off
100M Green Status indications of data speed on ETHERNET port.
On
Off
CF – Not Used
6 - 28
Table 6-11 CC-CP00 LED Indications (Continued)
MJ alarm
MN alarm
Normal status
Link is established
Link is established (When receiving a packet.)
Link is not established
100Mbps
10Mbps
3.2.5

Connectors

Table 6-12 CC-CP00 Connections

CD-CP00-AU
describes the pin-outs for connectors on the CCPU-A. Refer to
6-6 CC-CP00 Blade on page 6-22
on the CCPU-A1 blade.
Table 6-12 CC-CP00 Connections
Connector
CN1 Backboard connection
J13 VoIPDB connection
J8 VMDB connection
ETERNET Ethernet cable connection (for PCPro, SMDR, PMS or
OAI)
MOH Pin jack for external source connection (External MOH)
RELAY External source control connection
EX IN/EX OUT Unit synchronization connection for the wireless
system
RESET System reset switch
RS1/RS2 RS-232C port (for PCPro, SMDR, MCI or printer)
The CPU supports the following:
Expansion Chassis
DSPDB Daughter Board (providing 32 channels for the DTMF
Receiver, Call Progress Tone Detection and Caller ID Receivers)
Third-Party CTI/TAPI 2
16VOIPU Blade and 16VOIPDB
Status
describes each connector on the
Table 6-13 CC-CP00 Connector Pin-Outs on page 6-29
,
for the location of the connections
Connector Description
Installing the SV8100/SV8300 Blades
UNIVERGE SV8100/SV8300
Figure