Issue No. 1.5
5 - 24
3.3.2
CHS1U-AU+CHS2U-AUxN Chassis Installation
Expansion chassis (maximum of three) can be added to create a UNIT
and will require an additional CHS2U STAND KIT (EXT) per chassis.
1.
Using the spacing guide shown below, mark two holes to be
drilled. Refer to
(CHS1U-AU+CHS2U-AUXN Chassis Installation) on page 5-24
for required spacing before drilling.
Figure 5-26 Stand Mount Spacing Guide (CHS1U-AU+CHS2U-AUXN Chassis Installation)
UNIVERGE SV8100/SV8300
Figure 5-26 Stand Mount Spacing Guide
It is suggested that plywood first be
installed on the floor where the chassis
will be positioned. This allows for
secure anchoring of the screws which
will be supporting the weight of the
chassis.
For Stand Mounting, up to three
CHS2U-AU chassis can stand with a
CHS1U-AU chassis.
Installing the SV8300 Chassis