Setting The Built-In Ait; Setting With The Dip Switch - NEC N8151-50 User Manual

Setting the Built-In AIT

The DIP switch on the bottom of the Built-In AIT enables you to change the following settings.
• DC Control (1) (Data compression setting) (Factory-set to ON)
• DC Control (2) (Data compression setting) (Factory-set to OFF)
Setting data compression - DC Control (1) -
Set whether the Built-In AIT's data compression function is
enabled or disabled.
Use Switch 7. Setting Switch 7 to ON (factory-set to ON) will
enable the data compression function; setting Switch 7 to OFF will
disable the terminator data compression function.
Setting data compression - DC Control (2) -
Set whether control of data compression from the backup software
is enabled or disabled.
Use Switch 8. Setting Switch 8 to ON will disable control of data
compression from the backup application; setting Switch 8 to OFF
(factory-set to OFF) will enable control of data compression from
the backup software.

- Setting with the DIP switch -

Switches 1 to 6: Unused
Switch 7: DC Control (1)
Switch 8: DC Control (2)
ON
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Built-in AIT 75
ON
ON