Limits Checking Results - Keysight Technologies EPM-P Series Programming Manual

+10 dBm
+4 dBm
Figure 1-6
The power meter can be configured to verify the current measurement in any
measurement line against predefined upper and/or lower limit values. The range
of values that can be set for the upper and lower limits and the default values
depends on the measurement units in the currently measurement line - see
Table
Table 1-2
The limits can also be set to output a TTL logic level at the rear panel Rmt I/O port
when the predefined limits are exceeded. You can switch the rear panel TTL
outputs on or off; set the TTL output level to active high or low; and determine
whether the TTL output represents an over limit condition, under limit condition or
both. Refer to
Keysight EPM-P Series Programming Guide
Amplitude
o
o

Limits checking results

1-2.
Range of values for window limits
Window units
dB +200 dB
dBm +230 dBm
% 10.0 Z%
W 100.000 XW
Chapter 8, "OUTput Subsystem"
Fail
o
o o
o
o
Fail
Max Min
-180 dB
-150 dBm
100.0 a%
1.000 aW
Power Meter Remote Operation
Frequency
Defaul t
Max
60 dB
90 dBm
100.0 M%
1.000 MW
for TTL output programming
1
Min
-120 dB
-90 dBm
100.0 p%
1.000 pW
85