[Sense[1]]|Sense2:Average[:State] <Boolean - Keysight Technologies EPM-P Series Programming Manual

9 SENSe Subsystem
[SENSe[1]]|SENSe2:AVERage[:STATe] <boolean>
This command is used to enable and disable averaging.
Syntax
Example
Reset condition
On reset, averaging is enabled.
Query
[SENSe[1]]|SENSe2:AVERage[:STATe]?
The query enters a 1 or 0 into the output buffer indicating the status of averaging.
– 1 is returned when averaging is enabled.
– 0 is returned when averaging is disabled.
Query example
Error messages
If [SENSe[1]]|SENSe2:AVERage:STATe is set to ON while
[SENSe[1]]|SENSe2:SPEed is set to 200, the error -221, "Settings Conflict"
occurs.
362
SENS
1
SENS2
AVER 1
SENS2:AVER?
:
:STAT
AVER
This command enables averaging on
channel A.
This command queries whether averaging is
on or off for channel B.
Keysight EPM-P Series Programming Guide
Space
0|OFF
1|ON
?