Saving And Recalling Power Meter Configurations; How To Save And Recall A Configuration; Example Program - Keysight Technologies EPM-P Series Programming Manual

Saving and Recalling Power Meter Configurations

To reduce repeated programming, up to ten power meter configurations can be
stored in the power meter's non-volatile memory. The error list, GPIB address,
programming language, sensor calibration table data, zeroing and calibration
information are not stored.

How to save and recall a configuration

Power meter configurations are saved and recalled with the following commands:
*SAV <NRf>
*RCL <NRf>
The range of values for <NRf> in the above commands is 1 to 10.

Example program

10 ASSIGN @POWER TO 713
20 !Configure the power meter
30 OUTPUT @POWER;"UNIT:POW W"
40 OUTPUT @POWER;"SENS:CORR:LOSS2 -10"
50 OUTPUT @POWER;"SENS:CORR:LOSS2:STAT ON"
60 !Save the configuration
70 OUTPUT @POWER;"*SAV 5"
80 PRINT "Configuration Saved"
90 !Now reset the power meter
100 OUTPUT @POWER;"*RST"
110 !Recall the configuration
120 OUTPUT @POWER;"*RCL 5"
130 PRINT "Configuration Recalled"
140 PRINT "Save and Recall complete"
150 END
Keysight EPM-P Series Programming Guide
Power Meter Remote Operation 1
115