Service:sensor[1]|2:Corrections:state <Boolean - Keysight Technologies EPM-P Series Programming Manual

15 SERVice Subsystem
SERVice:SENSor[1]|2:CORRections:STATe <boolean>
This command enables/disables the voltage to corrected power conversion. It
applies to E9320 Series power sensors only.
Before setting this command to OFF, you must set the INIT:CONF command to
NOTE
OFF.
After setting this command to OFF, you must only run commands relating to the
gathering of ADC values—for example, the SERV:SENS:RADC command.
Syntax
Example
Reset condition
On reset, the value is set to OFF.
Query
SERVice:SENSor[1]|2:CORRections:STATe?
The query enters a 1 or 0 into the output buffer indicating the status of the
voltage to corrected power conversion.
– 1 is returned when voltage to corrected power conversion is enabled.
– 0 is returned when voltage to corrected power conversion is disabled.
588
SERV :SENS
SERV:SENS2:CORR:STAT ON
:CORR
1
2
This command enables the voltage to
corrected power conversion for channel B.
Keysight EPM-P Series Programming Guide
Space
:STAT
0|OFF
1|ON
?