Keysight Technologies EPM-P Series Programming Manual page 280

5 DISPlay Subsystem
Parameters
Item
numeric_value
Example
DISP:WIND2:MET:UPP 20
Reset condition
On reset, the upper scale limit is set to 20 dBm.
Query
DISPlay[:WINDow[1]|2]:METer:UPPer? [MIN|MAX]
The query returns the current setting of the analog meter's upper scale limit or the
value associated with MIN and MAX. The format of the response is <NR3>. The units
in which the results are returned is dependent on the current setting of
UNIT:POWer and CALCulate:RELative:STATe as shown in the previous table.
Query example
DISP:WIND2:MET:UPP?
280
Description/Defaul t
A numeric value for the analog meter upper scale limit:
– DEF: the default is -70 dBm
– MIN: -150 dBm
– MAX: 230 dBm
Units used are determined by the current setting of
UNIT:POWer and CALCulate:RELative:STATe as
shown in Table 5-4.
This command sets the lower
window's analog meter upper scale
limit.
This command queries the upper
scale limit set on the analog meter in
the lower window.
Keysight EPM-P Series Programming Guide
Range of values
-150 to 230 dBm
DEF
MIN
MAX