Keysight Technologies EPM-P Series Programming Manual page 482

11 SYSTem Subsystem
Table 11-1
Command
DISP:SCR:FORM
DISP[:WIND[1]|2]:ANAL:LOW
DISP[:WIND[1]|2]:ANAL:UPP
DISP[:WIND[1]|2]:FORM
DISP[:WIND[1]|2]:MET:LOW
DISP[:WIND[1]|2]:MET:UPP
DISP[:WIND[1]|2|][:NUM[1]|2]
:RES
DISP[:WIND[1]|2]:SEL[1]|2
DISP[:WIND[1]|2][:STAT]
DISP[:WIND[1]|2]:TRAC:LOW
DISP[:WIND[1]|2]:TRAC:UPP
FORM[:READ]:BORD
FORM[:READ][:DATA]
INIT[1]|2:CONT
MEM:TABL:SEL
OUTP:REC[1]|2:FEED
OUTP:REC[1]|2:LIM:LOW
OUTP:REC[1]|2:LIM:UPP
OUTP:ROSC:STAT
OUTP:TRIG:STAT
OUTP:TTL[1]|2:ACT
482
DEFault: Power meter presets (continued)
Setting Comments
WIND Display format set to windowed
-70 dBm Lower scale limit
20 dBm Upper scale limit
Keysight E4416A: Display format
Upper - digital
Lower - analog
Keysight E4417A
Upper - digital
Lower - digital
-70.000 dBm Analog meter lower limit
+20.000 dBm Analog meter upper limit
3 Window resolution
upper window Window selected
ON Both windows enabled on display
DEF Maximum power
DEF Minimum power
normal Binary order
ascii Data format
*RST: OFF Power Meter in idle state
SYS:PRES ON Power Meter in wait for trigger
state
not affected Active sensor calibration table
not affected Previous measurement
-150 dBm Minimum scaling value
20 dBm Maximum scaling value
OFF 50 MHz reference disabled
OFF Trigger output signal disabled
LOW TTL output active low
Keysight EPM-P Series Programming Guide