Keysight Technologies EPM-P Series Programming Manual page 149

Entering a <source list> is only required if you are using an E4417A. As the
E4416A has a single channel only, the source list can only be channel A.
The following commands are described in this chapter:
Keyword
CONFigure[1]|2|3|4
CONFigure[1]|2|3|4
[:SCALar]
[:POWer:AC]
:RELative
:DIFFerence
:RATio
FETCh[1]|2|3|4
[:SCALar]
[:POWer:AC]?
:RELative?
:DIFFerence?
Keysight EPM-P Series Programming Guide
Parameter form
[<expected_value>
[,<resolution>[,<source list>]]]
[<expected_value>
[,<resolution>[,<source list>]]]
[<expected_value>
[,<resolution>[,<source list>]]]
:RELative [<expected_value>
[,<resolution>[,<source list>]]]
[<expected_value>
[,<resolution>[,<source list>]]]
:RELative [<expected_value>
[,<resolution>[,<source list>]]]
[<expected_value>
[,<resolution>[,<source list>]]]
[<expected_value>
[,<resolution>[,<source list>]]]
[<expected_value>
[,<resolution>[,<source list>]]]
:RELative? [<expected_value>
[,<resolution>[,<source list>]]]
Measurement Commands
Notes Page
[query only] page -152
[no query] page -156
[no query]
page -158
[non-SCPI]
[no query]
page -160
[non-SCPI]
[no query]
page -162
[non-SCPI]
[no query]
page -164
[no query]
page -166
[non-SCPI]
[query only] page -169
[query only] page -171
[non-SCPI]
[query only] page -173
[non-SCPI]
[query only] page -175
[non-SCPI]
2
149