Preset Values - Keysight Technologies EPM-P Series Programming Manual

Preset values

DEFault
The following table shows the power meter presets when <character_data> is
set to DEFault or omitted. Values are shown for all SCPI commands:
Table 11-1
Command
CALC[1]|2|3|4:FEED[1]|2
CALC[1]|2|3|4:GAIN[:MAGN]
CALC[1]|2|3|4:GAIN:STAT
CALC[1]|2|3|4:LIM:CLE:AUTO
CALC[1]|2|3|4:LIM:LOW[:DATA]
CALC[1]|2|3|4:LIM:STAT
CALC[1]|2|3|4:LIM:UPP[:DATA]
CALC[1]|2|3|4:MATH[:EXPR]
CALC[1]|2|3|4:REL[:MAGN]:AUTO
CALC[1]|2|3|4:REL:STAT
CAL[1]|2:ECON:STAT
CAL[1]|2:RCAL
CAL[1]|2:RCF
DISP:CONT
DISP:ENAB
Keysight EPM-P Series Programming Guide
"Hardware missing: Higher bandwidth E9320 sensor required on channel X.
Measurements on channel X may be inaccurate" occurs.
DEFault: Power meter presets
SYSTem Subsystem
Setting Comments
"POW:AVER" Select average measurement type
0.000 dB Display offset value
OFF Display offset disabled
ON Clear limit data at INIT
-90 dBm Lower limit
OFF Window limits checking disabled
+90 dBm
Keysight E4416A: Math expression
Upper - channel A
Lower - channel A
Keysight E4417A
Upper - channel A
Lower - channel B
OFF Reference value disabled
OFF Relative offset disabled
OFF TTL zero/calibration inputs
disabled
not affected zero/cal lockout
100.0% Reference calibration factor
not affected Display contrast
ON Display enabled
11
481