[Sense[1]]|Sense2:Mrate <Character_Data - Keysight Technologies EPM-P Series Programming Manual

9 SENSe Subsystem
[SENSe[1]]|SENSe2:MRATe <character_data>
This command sets the measurement speed on the selected channel.
When a channel is set to FAST, the following couplings occur:
Command
[SENSe[1]]|SENSe2:AVERage:STATe
[SENSe[1]]|SENSe2:CORRection:DCYCle:STATe
[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe
CALCulate[1|2|3|4]:GAIN:STATe
CALCulate[1|2|3|4]:RELative:STATe
CALCulate1|3:MATH:EXPRession
CALCulate2|4:MATH:EXPRession
[a] This change only occurs on the channel specified in the SENSe:MRATe command. When the specified channel is
[b] This change occurs when either channel is set to FAST. When both channels are changed from FAST to NORMal
[c] Applicable to the E4417A dual channel power meter only.
FAST mode cannot be used over RS232 or RS422 serial interfaces.
NOTE
Syntax
394
changed from FAST to NORMal or DOUBle, the settings that were in place when FAST was entered are restored.
or DOUBle, the settings that were in place when FAST was entered are restored.
:
SENS
1
SENS2
Space
MRAT
Keysight EPM-P Series Programming Guide
Status
[a]
OFF
[a]
OFF
[a]
OFF
[b]
OFF
[b]
OFF
"(SENSe1)"
"(SENSe2)"
numeric_value
?
[c]