System:communicate:serial Commands - Keysight Technologies EPM-P Series Programming Manual

11 SYSTem Subsystem

SYStem:COMMunicate:Serial Commands

These commands control the settings for the RS232/RS422 serial interface. The
commands allow you to:
– Set the function of the DTR and RTS signal lines.
– Set the transmit/receive baud rate.
– Set the transmit/receive word length.
– Set the transmit/receive parity type.
– Set the transmit/receive stop bits.
– Enable /disable XON/XOFF software handshaking.
The following commands are detailed in this section:
SYSTem:COMMunicate:SERial:CONTrol:DTR
SYSTem:COMMunicate:SERial:CONTrol:RTS
SYSTem:COMMunicate:SERial:[:RECeive]:BAUD
SYSTem:COMMunicate:SERial:[:RECeive]:BITs
SYSTem:COMMunicate:SERial:[:RECeive]:PACE
SYSTem:COMMunicate:SERial:[:RECeive]:PARity:[TYPE]
SYSTem:COMMunicate:SERial:[:RECeive]:SBITs
SYSTem:COMMunicate:SERial:TRANsmit:AUTO?
SYSTem:COMMunicate:SERial:TRANsmit:BAUD
SYSTem:COMMunicate:SERial:TRANsmit:BITs
SYSTem:COMMunicate:SERial:TRANsmit:ECHO
SYSTem:COMMunicate:SERial:TRANsmit:PARity:[TYPE]
SYSTem:COMMunicate:SERial:TRANsmit:SBITs
452 Keysight EPM-P Series Programming Guide