Fetch[1]|2|3|4[:Scalar][:Power:ac]:Relative? [<Expected_Value>[,<Resolution>[,<Source List>]]] - Keysight Technologies EPM-P Series Programming Manual

FETCh[1]|2|3|4[:SCALar][:POWer:AC]:RELative?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window's measurement function to single
channel with relative mode on, recalculates the measurement and places the
results on the bus. The result is a ratio based measurement and is expressed in the
units defined by UNIT[1]|2|3|4:POWer:RATio. The relative value used is that
set by the CALCulate:RELative:MAGNitude:AUTO command.
Syntax
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected power
level)
Keysight EPM-P Series Programming Guide
FETC
1 :SCAL
2
3
Space
4
"Optional parameters"
Description/Defaul t
The expected power level parameter can be set to DEF
or a numeric value. If a value is entered it should
correspond to that set by CONFigure otherwise an
error occurs. The units of measurement are dBm and
W. The default units are defined by UNIT:POWer.
:POW :AC :REL
,
expected_value
DEF
on page 148 for additional details on the
Measurement Commands
?
,
resolution
DEF
Range of values
sensor dependent
[a]
DEF
2
source list
171