Trigger[:Sequence]:Holdoff <Numeric_Value - Keysight Technologies EPM-P Series Programming Manual

13 TRIGger Subsystem
TRIGger[:SEQuence]:HOLDoff <numeric_value>
This command sets the trigger holdoff in seconds.
The command is accepted for TRIGger[:SEQuence[1]] (channel A) only, for
NOTE
both single and dual channel power meters.
Syntax
Parameters
Item
numeric_value
Example
Reset condition
On reset the trigger holdoff is set to 1 us.
548
:SEQ
TRIG
Description/Defaul t
The trigger holdoff in seconds.
DEF: the
–
– MIN: 1 us.
– MAX: 400 ms.
Units are resolved to 100 ns.
TRIG:SEQ1:HOLD 0.1
:HOLD Space
default value is 1 us.
This command sets the trigger holdoff to
100 ms for channel A.
Keysight EPM-P Series Programming Guide
numeric_value
DEF
MIN
MAX
?
Range of values
1 us to 0.4 seconds
DEF
MIN
MAX