Status Register Set Commands; Condition - Keysight Technologies EPM-P Series Programming Manual

Power meters

Hide thumbs Also See for EPM-P Series:

Table of Contents

STATus Subsystem

Status Register Set Commands

This section describes the five status register set commands. Each can be used to

examine all of the eleven status registers listed on the previous page.

To apply a command to a specific register, prefix the command with the name of

the appropriate register. For example, to apply the :ENABle command to the

STATus:QUEStionable register, use the following command:

STATus:QUEStionable:ENABle.

The Status Register Set commands detailed in this section are:

:NTRansition

:PTRansition

This query returns a 16 bit decimal-weighted number representing the bits set in

the Condition Register of the SCPI Register Set you require to control. The format

of the return is <NR1> in the range of 0 to 32767 (2

Condition Register remain unchanged after it is read.

Parameter form

[query only]

-1). The contents of the

Keysight EPM-P Series Programming Guide

Table of Contents