Keysight Technologies EPM-P Series Programming Manual page 106

1 Power Meter Remote Operation
Table 1-4
Bit number
0
1
2
3
4
5
6
7
The standard event register is cleared when you:
– send a *CLS (clear status) command.
– query the event register using the *ESR? (event status register) command.
The standard event enable register is cleared when you:
– cycle the instrument power.
– execute a *ESE 0 command.
106
Bit definitions - standard event register
Decimal value Definition
Operation Complete
1
All overlapped commands following an
completed.
2 Not Used. (Always set to 0.)
Query Error
4 A query error occurred, refer to error numbers 410 to 440 in the
User's Guide.
Device Error
8 A device error occurred, refer to error numbers 310 to 350 in the
User's Guide.
Execution Error
16 An execution error occurred, refer to error numbers 211 to 241 in the
User's Guide.
Command Error
32 A command syntax error occurred, refer to error numbers 101 to 161
in the User's Guide.
64 User request.
Power On
128 Power has been turned off and on since the last time the event
register was read or cleared.
*OPC
Keysight EPM-P Series Programming Guide
command have been