Output:trigger[:State] <Boolean - Keysight Technologies EPM-P Series Programming Manual

OUTPut:TRIGger[:STATe] <boolean>
This command enables/disables the trigger output signal.
Syntax
Example
OUTP:TRIG:STAT 1
Reset condition
On reset, the trigger output signal is disabled.
Query
OUTPut:TRIGger[:STATe]?
The query command enters a 1 or 0 into the output buffer indicating whether or
not the trigger output signal is enabled/disabled.
– 1 is returned when the trigger output signal is enabled.
– 0 is returned when the trigger output signal is disabled.
Query example
OUTP:TRIG:STAT?
Keysight EPM-P Series Programming Guide
OUTP
:TRIG
Space
:STAT
This command enables the trigger
output signal.
This command queries the status of
the trigger output signal.
OUTput Subsystem
0|OFF
1|ON
?
8
341