Configure[1]|2|3|4[:Scalar][:Power:ac]:Ratio [<Expected_Value>[,<Resolution>[,<Source List>]]] - Keysight Technologies EPM-P Series Programming Manual

2 Measurement Commands
CONFigure[1]|2|3|4[:SCALar][:POWer:AC]:RATio
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the measurement function, range and resolution of the
specified window. It sets the measurement function to ratio with relative mode off.
Syntax
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected power
level)
resolution
source list
[a] The mnemonic
164
CONF
:SCAL
1
2
3
Space
4
"Optional parameters"
Description/Defaul t
The power meter ignores the numeric value entered in
this parameter. Any value entered is treated like DEF.
A numeric value for the resolution. If unspecified the
current resolution setting is used.
This channel list specifies the channels used to
calculate the ratio. If unspecified and the current
window setup is a ratio measurement then this ratio
setup is used, otherwise it defaults to channel A/B
(E4417A) or A/A (E4416A).
means DEFault. This is not equivalent to the DEFault parameter used in the command
DEF
sub-systems. The parameters must be entered in the specified order. If parameters are omitted, they will default
from the right. The parameter DEFault is used as a place holder. Specifying
unchanged.
:RAT
:POW :AC
,
expected_value
DEF
on page 148 for additional details on the
Keysight EPM-P Series Programming Guide
,
resolution source list
DEF
Range of values
sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF
(@1),(@2)
(@2),(@1)
(@1),(@1)
(@2),(@2)
leaves the parameter value
DEF
[c]
[c]
[c]