Calculate[1]|2|3|4:Phold:clear - Keysight Technologies EPM-P Series Programming Manual

3 CALCulate Subsystem

CALCulate[1]|2|3|4:PHOLd:CLEar

This command clears the peak hold value for a specified CALC block so that a new
peak hold value can be set.
Clearing the peak hold value for a specified CALC block may affect the peak hold
NOTE
value of other CALC blocks, depending on the CALC channel set up (set by
CALC:MATH:EXPR).
Syntax
Example
CALC2:PHOLd:CLEar
Error messages
– If no power sensor is connected, error -241 "Hardware missing" occurs.
– If a non E9320 Series power sensor is connected, error -241 "Hardware
– If SENS:DET:FUNC is set to AVER or TRIG:SOUR is set to INT1, INT2 or EXT,
236
:PHOL
CALC
1
2
3
4
missing" occurs.
error -221 "Settings conflict" occurs.
:CLE
This command clears the peak hold
value for CALC2.
Keysight EPM-P Series Programming Guide