Fetch[1]|2|3|4[:Scalar][:Power:ac]? [<Expected_Value>[,<Resolution>[,<Source List>]]] - Keysight Technologies EPM-P Series Programming Manual

FETCh[1]|2|3|4[:SCALar][:POWer:AC]?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window's measurement function to single
channel with relative mode off, recalculates the measurement and places the
result on the bus. The result is a power based measurement and is expressed in
the units defined by UNIT[1]|2|3|4:POWer.
Syntax
Parameters
Refer to
parameters in this command.
Item
expected_value
(for the expected power
level)
resolution
source list
Keysight EPM-P Series Programming Guide
FETC
:SCAL
1
2
3
Space
4
"Optional parameters"
Description/Defaul t
The expected power level parameter can be set to DEF
or a numeric value. If a value is entered it should
correspond to that set by CONFigure otherwise an
error occurs. The units of measurement are dBm and
W. The default units are defined by UNIT:POWer.
A numeric value for the resolution. If it is unspecified
the current resolution setting is used. If a value is
entered it should correspond to the current resolution
setting otherwise an error occurs.
The channel which the command is implemented on. If
unspecified the current window setup is used.
However, on the E4417A, if the window shows a ratio
or difference measurement, the upper window
defaults to channel A and the lower window to channel
B.
:AC
:POW ?
,
expected_value
DEF
on page 148 for additional details on the
Measurement Commands
,
resolution source list
DEF
Range of values
sensor dependent
[a]
DEF
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF
(@1)
(@2) (E4417A only)
2
[b]
169