Keysight Technologies EPM-P Series Programming Manual page 327

Parameters
Item
numeric_value
Example
MEM:TABL:SEL "Sensor_1"
MEM:TABL:GAIN 97,99.5,97.4
Query
MEMory:TABLe:GAIN[:MAGNitude]?
The query returns a list of calibration factor/offset points for the currently selected
table.
Query example
MEM:TABL:GAIN?
Error messages
– If more than 81 calibration factors for sensor calibration tables, or 80 offsets
– If a table is not specified using the MEMory:TABLe:SELect command, the
– If any of the calibration/offset factors are outside of the allowed range, error
Keysight EPM-P Series Programming Guide
Description/Defaul t
A numeric value for the calibration/ offset factors. The units
are PCT.
for frequency dependent offset tables are in the list, error -108, "Parameter not
allowed" occurs.
data cannot be entered and error -221, "Settings conflict" occurs.
-222, "Data out of range" occurs.
MEMory Subsystem
This command enters a reference
calibration factor of 97% and
calibration factors of 99.5% and
97.4% into the sensor calibration
table.
This command queries the calibration
factor/offset in the current table.
7
Range of values
1.0 to 150.0
327