System:preset <Character_Data - Keysight Technologies EPM-P Series Programming Manual

SYSTem:PRESet <character_data>
This command presets the power meter to values appropriate for measuring the
communications format specified by <character_data>. The power meter is
preset to default values if no value or if the value DEFault is supplied.
DEFault settings apply to both *RST and to SYSTem:PREset DEFault unless
NOTE
stated otherwise.
For further information on preset configurations, refer to
Tables 11-1 to 11-25.
Command results differ according to the sensor(s) connected to the power meter:
– If both an E9320 sensor and non-E9320 sensor are connected to a dual
– If two E9320 sensors are connected to a dual channel power meter, both
Primary and secondary channels
Dual channel meter channels are defined as either primary or secondary. The
primary channel is always the trigger master and primary channel measurements
occupy a greater share of the display space than secondary channel
measurements.
– If a dual channel meter has one E9320 sensor connected, the E9320 sensor
– If a dual channel meter has two E9320 sensors connected to it, the primary
Syntax
Keysight EPM-P Series Programming Guide
channel power meter, the channel connected to the E9320 sensor is set up
according to the <character_data> value and the non-E9320 channel is set
to DEFault values.
channels are set to the same values except for bandwidth which is set to an
appropriate value for each sensor.
channel is the primary channel. In such cases the primary channel could be
either channel A or channel B. The non-E9320 channel is the secondary
channel.
channel is always channel A and the secondary channel is channel B.
:PRES
SYST
Space character_data
SYSTem Subsystem 11
479