System Subsystem - Keysight Technologies EPM-P Series Programming Manual

11

SYSTem Subsystem

SYSTem Subsystem

The SYStem command subsystem is used to:
– Return error numbers and messages from the power meter.
– Preset the power meter.
– Select the remote interface type (GPIB, RS232 orRS422).
– Set the GPIB address.
– Set the command language.
– Query the SCPI version.
At a lower level:
– SYSTem:COMMunicate:SERial:CONTrol sets the DTR and RTS signal lines.
– SYSTem:COMMunicate:SERial:CONTrol[:RECeive] and TRANsmit sets
Keyword
SYSTem
448
baud rate, parity, word length and other serial interface controls.
:COMMunicate
:GPIB
[:SELF]
:ADDRess
:SERial
:CONTrol
:DTR
:RTS
[:RECeive]
:BAUD
:BITs
:PACE
:PARity
Parameter form
<numeric_value>
<boolean>
<boolean>
<numeric_value>
<numeric_value>
XON|NONE
Keysight EPM-P Series Programming Guide
Notes Page
page -450
page -453
page -455
page -456
page -458
page -460