Keysight Technologies EPM-P Series Programming Manual page 107

Questionable status register
The questionable status register provides information about the quality of the
power meter's measurement results. Any or all of these conditions can be
reported in the questionable data summary bit through the enable register. You
must write a value using the STATus:QUEStionable:ENABle command to set
the enable register mask.
The questionable status model is shown in the pullout at the end of this chapter.
The following bits in these registers are used by the power meter.
Bit number
0 to 2
3
4 to 7
8
9
10 to 14
15
Keysight EPM-P Series Programming Guide
Decimal weight Definition
- Not used
8 POWer Summary
- Not used
256 CALibration Summary
512 Power On Self Test
- Not Used
- Not used (always 0)
Power Meter Remote Operation 1
107