Sre <Nrf - Keysight Technologies EPM-P Series Programming Manual

*SRE <NRf>
The *SRE <NRf> command sets the Service Request Enable register bits. This
register contains a mask value for the bits to be enabled in the Status Byte
Register. A 1 in the Enable Register enables the corresponding bit in the Status
Byte Register; a 0 disables the bit. The parameter value, when rounded to an
integer and expressed in base 2, represents the bits 0 to 5 and bit 7 of the Service
Request Enable Register. Bit 6 is always 0. Table shows the contents of this
register. Refer to the pullout at the end of chapter 1 for further information.
Table 16-5
Bit
0
1
2
3
4
5
6
7
Syntax
Parameters
Type
NRf
Keysight EPM-P Series Programming Guide
*SRE mapping
Weight
1
2
4
8
16
32
64
128
Space
*SRE
Description/Defaul t
A value used to set the Service Request Enable Register. 0 - 255
IEEE488.2 Command Reference
Meaning
Not used
Not used
Device Dependent
QUEStionable Status Summary
Message Available
Event Status Bit
Not used
OPERation Status Summary
NRf
?
16
Range of values
623