Keysight Technologies EPM-P Series Programming Manual page 163

Item
expected_value
(for the expected power
level)
resolution
source list
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command
[b] When the measurement result is linear this parameter represents the number of significant digits. When the
[c] E4417A only.
Example
CONF1:DIFF:REL DEF,1,(@1),(@2)
Keysight EPM-P Series Programming Guide
Description/Defaul t
The power meter ignores the numeric value entered in
this parameter. Any value entered is treated like DEF.
A numeric value for the resolution. If unspecified the
current resolution setting is used.
This channel list specifies the channels used to
calculate the difference.
If unspecified and the current window setup is a
difference measurement then this difference setup is
used, otherwise it defaults to channel A-B (E4417A) or
A-A (E4416A).
sub-systems. The parameters must be entered in the specified order. If parameters are omitted, they will default
from the right. The parameter DEFault is used as a place holder. Specifying DEF leaves the parameter value
unchanged.
measurement result is logarithmic 1 to 4 represents a resolution of 1, 0.1, 0.01 and 0.001 respectively..
Measurement Commands
This command configures the
upper window to make a difference
measurement of
channel A - channel B with relative
mode on, using the current sensor
range and a resolution of 1 on both
channels.
2
Range of values
sensor dependent
[a]
DEF
[b]
1 to 4
1.0, 0.1, 0.01, 0.001
[a]
DEF
[c]
(@1),(@2)
[c]
(@2),(@1)
(@1),(@1)
[c]
(@2),(@2)
163