Sense[1]]|Sense2:Correction:fdoffset|Gain4[:Input][:Magnitude - Keysight Technologies EPM-P Series Programming Manual

Power meters

Hide thumbs Also See for EPM-P Series:

Table of Contents

Error messages

– If [SENSe[1]]|SENSe2:CORRection:DCYCle:STATus is set to ON while

– If this command is used when an E4410 E-Series powers sensor is connected,

Keysight EPM-P Series Programming Guide

[SENSe[1]]|SENSe2:SPEed is set to 200, the error -221, "Settings Conflict"

the error -310, "System error;Dty Cyc may impair accuracy with ECP sensor"

occurs. If you are using the E4417A the error message specifies the channel.

SENSe Subsystem

Chapters

Table of Contents