Keysight Technologies EPM-P Series Programming Manual page 505

Table 11-19
Function
Display setup
Upper window
Lower window
Upper window/lower measurement (UL)
Feed
Measurement
Lower window/upper measurement (LU)
Feed
Measurement
Lower window/lower measurement (LL)
Feed
Measurement
[a] For further information refer to
CDMA2000
The cdma2000 set-up provides:
– Average power in a cdma2000 signal (bandwidth <=5MHz).
– Peak power and peak-to-average ratio of the signal over a defined, statistically
The measurement is a continuously gated measurement on a 3GPP cdma2000
signal. Its aim is to measure the peak and average power corresponding to a
<0.01% probability that there are no peaks above the returned peak reading. Time
gating is set to 10ms, corresponding to 200,000 samples. Triggering is set to
Keysight EPM-P Series Programming Guide
WCDMA: Power meter presets for secondary channel sensors
No sensor
UU single numeric
Dual numeric
DEF
DEF
Gate 1 primary channel
Peak
Gate 1 primary channel
Peak to avg
valid number of samples. The reading is continuously refreshed. This indicates
how cdma2000 channel loading affects peak power and power distribution.
Secondary channel sensor
Non E9320 sensor
Dual numeric
Dual numeric
Gate 1 primary channel
Peak
[a]
Gate 1 primary channel
Peak to avg
[a]
Secondary channel
Avg
"Primary and secondary channels"
SYSTem Subsystem
E9320 sensor
Dual numeric
Dual numeric
Gate 1 primary
[a]
[a]
channel (channel A)
Peak
Gate 1 secondary
[a]
[a]
channel (channel B)
Avg
Gate1 secondary
[a]
[a]
channel (channel B)
Peak to avg
on page 479.
11
505