A Trace Display Of The Active Timeslots - Keysight Technologies EPM-P Series Programming Manual

11 SYSTem Subsystem
Table 11-7
Function
Display setup
Lower window
Lower window/lower measurement (LL)
Feed
Measurement
[a] For further information refer to
NADC
The NADC set-up provides:
– Average power measurement of both active timeslots in NADC or IS-136 "full
Figure 11-1

– A trace display of the active timeslots.

The measurement is started by detecting the RF burst—for example the burst
emitted by a mobile—using the internal RF level trigger. The internal level trigger
is set to –20dBm. Time-gating is used to measure the average power in two active
timeslots which are separated by two inactive timeslots
492
EDGE: Power meter presets For secondary channel sensors
No sensor
Dual numeric
Gate 1 primary channel
Peak to avg
rate" transmission. This assumes that there are two timeslots to be measured
in each frame as for example with timeslots 0 in the following diagram:
IS-136 full rate frame
0 1
A trace display of the active timeslots
Secondary channel sensor
Non E9320 sensor
Dual numeric
[a]
Secondary channel
Avg
"Primary and secondary channels"
2 0
Keysight EPM-P Series Programming Guide
E9320 sensor
Dual numeric
Gate1 secondary
[a]
channel
Avg
on page 479.
1 2
[a]
(channel B)