Keysight Technologies EPM-P Series Programming Manual page 496

11 SYSTem Subsystem
which lasts for 366us. The DHI burst does not occupy a full Bluetooth timeslot,
which lasts for 625us.
The following table shows the power meter presets when <character_data> is
set to BLUetooth. Commands not listed are preset according to their DEFault
values (for further information refer to Table 11-1):
Table 11-11
Command
Frequency
[SENS[1]]|SENS2:FREQ[:CW|:FIX] +2400.000 MHz
Sensor measurement mode
[SENS[1]]|SENS2:DET:FUNC
Sensor video band wid th setup
[SENS[1]]|SENS2:BAND|BWID:VID
Gate setup
[SENS[1]]|SENS2:SWE[1]|2|3|4
:OFF:TIME
[SENS[1]]|SENS2:SWE[1]|2|3|4
:TIME
Trigger setup
TRIGger[:SEQuence[1]|2]:SOUR
INIT:CONT
TRIG[:SEQ]:LEV:AUTO
TRIG[:SEQ]:LEV
TRIG[:SEQ]:SLOP
TRIG[:SEQ]:DEL
496
BLUetooth: Power meter presets
Setting
NORM
E9321A/25A: DEF
E9322A/26A: HIGH
E9323A/27A: MEDium
Gate 1: 0.2 us
Gates 2 - 4: 0
Gate 1: 366 us
Gates 2 - 4: 0
INT1
ON
OFF
-20 dBm
POS
0
Keysight EPM-P Series Programming Guide
Comments
Frequency setting
Measurement mode
Sensor video bandwidth
Delay between trigger point and
time gated period.
Length of time gated period for
time gated measurements.
Trigger source set up and
acquisition mode continuous
triggering
Disable automatic setting of the
trigger level
Power level
Trigger event recognized on the
rising edge of a signal
Delay between recognition of
trigger event and start of a
measurement