Keysight Technologies EPM-P Series Programming Manual page 167

[a] The mnemonic
[b] When the measurement result is linear this parameter represents the number of significant digits. When the
[c] E4417A only.
Example
CONF1:RAT:REL DEF,1,(@1),(@2)
Keysight EPM-P Series Programming Guide
means DEFault. This is not equivalent to the DEFault parameter used in the command
DEF
sub-systems. The parameters must be entered in the specified order. If parameters are omitted, they will default
from the right. The parameter DEFault is used as a place holder. Specifying
unchanged.
measurement result is logarithmic 1 to 4 represents a resolution of 1, 0.1, 0.01 and 0.001 respectively.
Measurement Commands
leaves the parameter value
DEF
This command configures the
upper window to make a ratio
measurement of channel A over
channel B with relative mode on,
using the current sensor range
and a resolution setting of 1 on
both channels.
2
167