[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Commands
These commands are used to select the active sensor calibration table (using
CSET1) and the active frequency dependent offset table (using CSET2).
If any of the CSET1 commands are used when an E-Series power sensor or
NOTE
N8480 Series power sensor (excluding Option CFT) is connected, the error -241,
"Hardware missing" occurs.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2
[:SELect] <string>
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe <boolean>
Keysight EPM-P Series Programming Guide
SENSe Subsystem
9
373