Table of Contents
Advertisement
4 Repair
4.6.3 Replacing the gear wheel
Continued
2
3
4
5
6
7
Continues on next page
226
Action
CAUTION
The motor weighs 11 kg. All lifting accessories
used must be sized accordingly!
Attach the lifting chains to the eye bolts on the
motor and lift the motor into position on the
track with guidance from the locating cylindrical
pin.
Fit the drive train on the drive train bracket with
the screws and plain washers.
Note
Do not tighten the screws yet.
Adjust the backlash of the gear motor. For how
to adjust the gear motor backlash, see
ing the gearbox backlash on page
Tighten the screws and plain washers in se-
quence shown in the illustration.
For the mirrored cable chain orientation, refit
the cable chain support with two screws.
Reconnect the power and signal cables to the
motor.
© Copyright 2015 - 2018 ABB. All rights reserved.
Illustration/Note
xx1400001627
A Ø 17xØ 11x2 washer,
3HAB4233-1
B M10x40 hex socket head cap
installation screw, 3HAB3409-
50 (8 pcs)
C Cable chain support
Adjust-
229.
xx1400001630
Tightening torque: 70 Nm
Product manual - IRBT 2005
3HAC051130-001 Revision: F
Advertisement
Table of Contents
