ABB IRBT 2005 Product Manual page 160

3 Maintenance
3.4.1 Inspecting the automatic lubrication system
Continued
Required equipment
Required tool
Equipment
Standard toolkit
Other tools and procedures
may be required. See refer-
ences to these procedures in
the step-by-step instructions
below.
Required lubricant
Equipment
Lubricant
Lubricant
Inspecting the grease level and inspecting the pipes
Use this procedure to inspect the grease level and inspect the pipes of the
lubrication system.
1
2
Continues on next page
160
WARNING
Use lithium soap flowable grease, class NLGI 0, with a mineral oil base, doped
with EP (extreme pressure) additives. The base oil viscosity must be ISO VG68
to ISO VG 100.
Grease doped with EP additives is absolutely necessary, due to high loads on
blocks.
Action
Locate the cartridge.
Check the level of lubricant, if necessary
replace the cartridge. For information about
cartridge replacement, see
grease cartridge in grease pump MEMOL-
®
UB EPS on page 140.
© Copyright 2015 - 2018 ABB. All rights reserved.
Art. No.
-
Note
KLÜBER Microlube GB0
TOTAL Multis EP 0
Illustration/Note
Replacing the
xx1400001754
A Checking lubrication cup level
through the notch
Note
Content is defined in section
Standard tools on page 276.
These procedures include
references to the tools re-
quired.
Product manual - IRBT 2005
3HAC051130-001 Revision: F