Table of Contents
Advertisement
3 Maintenance
3.5.1 Inspecting the cable chain
Continued
Location of the glide shoes
The figure shows the location of the glide shoes on the cable chain.
xx1400002683
Inspecting the glide shoes
1
2
Inspecting the strapping
1
Continues on next page
166
Action
Check the thickness of the glide shoes. If it is
less than 1.5 mm the glide shoes must be re-
placed.
Normally only the glide shoes in the area that
make first contact when the chain transitions
into gliding mode need to be checked. However
due to process cycle variation in factories it is
recommended to check all the glide shoes for
the first inspection and note the point of wear
for the next inspection.
Make an overall inspection of the glide shoes.
Replace broken or missing shoes.
Action
Check that strapping is in place. Each cable is
required to be individually strapped down, and
not bunched together.
If insufficient holes are available in the connec-
tion plates for individual strapping with cable
ties, the cables should be secured in such a
way that they cannot move.
Only use heavy duty cable ties, specified in
Required equipment on page
has been replaced ensure that a paint pen is
used to mark both sides of the cable tie.
© Copyright 2015 - 2018 ABB. All rights reserved.
Illustration/Note
See
Refitting the glide shoes on
page
252.
Illustration/Note
164. If strapping
Product manual - IRBT 2005
3HAC051130-001 Revision: F
Advertisement
Table of Contents
