Bus; Bus Mode; Separate Bus; Multiplexed Bus - Renesas M16C/62P Series Hardware Manual

M16C/62P Group (M16C/62P, M16C/62PT)
8.

Bus

Note
The M16C/62P (80-pin version) and M16C/62PT do not use bus control pins.
During memory expansion or microprocessor mode, some pins serve as the bus control pins to perform data input/
output to and from external devices. These bus control pins include A0 to A19, D0 to D15, CS0 to CS3, RD, WRL/
WR, WRH/BHE, ALE, RDY, HOLD, HLDA and BCLK.
8.1

Bus Mode

The bus mode, either multiplexed or separate, can be selected using the PM05 to PM04 bits in the PM0 register.
Table 8.1 shows the Difference Between a Separate Bus and Multiplexed Bus.
8.1.1

Separate Bus

In this bus mode, data and address are separate.
8.1.2

Multiplexed Bus

In this bus mode, data and address are multiplexed.
8.1.2.1 When the input level on BYTE pin is high (8-bit data bus)
D0 to D7 and A0 to A7 are multiplexed.
8.1.2.2 When the input level on BYTE pin is low (16-bit data bus)
D0 to D7 and A1 to A8 are multiplexed. D8 to D15 are not multiplexed. Do not use D8 to D15. External devices
connecting to a multiplexed bus are allocated to only the even addresses of the microcomputer. Odd
addresses cannot be accessed.
Table 8.1 Difference Between a Separate Bus and Multiplexed Bus
(1)
Pin Name
P0_0 to P0_7/D0 to D7
P1_0 to P1_7/D8 to D15
P2_0/A0 (/D0/-)
P2_1 to P2_7/A1 to A7
(/D1 to D7/D0 to D6)
P3_0/A8 (/-/D7)
NOTES:
1. See Table 8.6 Pin Functions for Each Processor Mode for bus control signals other than the
above. Setting Processor Modes.
2. It changes with a setup of PM05 to PM04, and area to access.
See Table 8.6 Pin Functions for Each Processor Mode for details.
Rev.2.41 Jan 10, 2006
REJ09B0185-0241
http://www.xinpian.net
Separate Bus
D0 to D7
D8 to D15
A0
A1 to A7
A8
Page 59 of 390
提供单片机解密、IC解密、芯片解密业务
Multiplex Bus
BYTE = H
(NOTE 2)
I/O Port
P1_0 to P1_7
A0 D0
A1 to A7 D1 to D7
A8
010-62245566 13810019655

8. Bus

BYTE = L
(NOTE 2)
(NOTE 2)
A0
A1 to A7 D0 to D6
A8 D7