Table of Contents
Advertisement
M16C/62P Group (M16C/62P, M16C/62PT)
18.1.3
Single Sweep Mode
In single sweep mode, analog voltage that is applied to selected pins is converted one-by-one to a digital code.
Table 18.4 shows the Single Sweep Mode Specifications. Figure 18.7 shows the ADCON0 Register and
ADCON1 Register (Single Sweep Mode).
Table 18.4
Single Sweep Mode Specifications
Item
Function
A/D Conversion Start
Condition
A/D Conversion Stop
Condition
Interrupt Request
Generation timing
Analog Input Pin
Reading of Result of A/D
Converter
NOTES:
1. AN0_0 to AN0_7, and AN2_0 to AN2_7 can be used in the same way as AN0 to AN7. However, if
VCC2 < VCC1, do not use AN0_0 to AN0_7 and AN2_0 to AN2_7 as analog input pins.
Rev.2.41
Jan 10, 2006
REJ09B0185-0241
http://www.xinpian.net
The SCAN1 to SCAN0 bits in the ADCON1 register and the ADGSEL1 to
ADGSEL0 bits in the ADCON2 register select pins. Analog voltage applied to
this pins is converted one-by-one to a digital code.
• When the TRG bit in the ADCON0 register is "0" (software trigger)
The ADST bit in the ADCON0 register is set to "1" (A/D conversion starts)
• When the TRG bit is "1" (ADTRG trigger)
Input on the ADTRG pin changes state from high to low after the ADST bit is
set to "1" (A/D conversion starts)
• Completion of A/D conversion (If a software trigger is selected, the ADST bit
is cleared to "0" (A/D conversion halted))
• Set the ADST bit to "0"
Completion of A/D conversion
Select from AN0 to AN1 (2 pins), AN0 to AN3 (4 pins), AN0 to AN5 (6 pins),
(1)
AN0 to AN7 (8 pin)
Read one of the AD0 to AD7 registers that corresponds to the selected pin
Page 242 of 390
提供单片机解密、IC解密、芯片解密业务
Specification
010-62245566 13810019655
18. A/D Converter
Advertisement
Table of Contents
