Renesas M16C/62P Series Hardware Manual page 302

M16C/62P Group (M16C/62P, M16C/62PT)
22.3.5.4 Program Command (40h)
The program command writes 2-byte data to the flash memory. By writing "xx40h" in the first bus cycle and
data to the write address in the second bus cycle, an auto program operation (data program and verify) will start.
The address value specified in the first bus cycle must be the same even address as the write address specified in
the second bus cycle.
The FMR00 bit in the FMR0 register indicates whether an auto program operation has been completed. The
FMR00 bit is set to "0" (busy) during auto program and to "1" (ready) when an auto program operation is
completed.
After the completion of an auto program operation, the FMR06 bit in the FMR0 register indicates whether or
not the auto program operation has been completed as expected. (Refer to 22.3.8 Full Status Check.)
An address that is already written cannot be altered or rewritten.
Figure 22.10 shows a Flow Chart of the Program Command Programming.
The lock bit protects each block from being programmed inadvertently. (Refer to 22.3.6 Data Protect
Function.)
In EW1 mode, do not execute this command on the block where the rewrite control program is allocated.
In EW0 mode, the microcomputer enters read status register mode as soon as an auto program operation starts.
The status register can be read. The SR7 bit in the status register is set to "0" at the same time an auto program
operation starts. It is set to "1" when auto program operation is completed. The microcomputer remains in read
status register mode until the read array command is written. After completion of an auto program operation,
the status register indicates whether or not the auto program operation has been completed as expected.
Figure 22.10 Program Command
Rev.2.41 Jan 10, 2006
REJ09B0185-0241
http://www.xinpian.net
Write the command code "xx40h"
to an address to be written
NOTES:
1. Write the command code and data to even addresses.
Page 287 of 390
提供单片机解密、IC解密、芯片解密业务
Start
Write data to an
address to be written
NO
FMR00=1?
YES
Full status check
Program operation is
completed
22. Flash Memory Version
010-62245566 13810019655